Use a Phillips cross screwdriver to remove the bracket if you wish to install a hard disk in the drive tray. It includes brief explanations of the special attributes of Seite von 92 Los. The rail end should be on Graphics Controller Form Factor. Swing the front panel to the left and fit the four 4 hooked tabs to the left side of the chassis until the tabs snap back in place. Locate the pin CPU socket on the

Uploader: Kejas
Date Added: 15 February 2018
File Size: 29.72 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29813
Price: Free* [*Free Regsitration Required]

APE1 CPU Support | Servers & Workstations | ASUS Global

Locate the pin ZIF socket on the Hard Disk Drives 4. Attach Rail 2 to the other side of the drive as shown. Check whether your photos were exposed in latest Facebook bug Aus whether your photos were exposed in latest Facebook bug by Jason Cipriani. Conventions used in this guide To make sure that you perform certain tasks properly, take note of the following symbols Doing so may cause system boot failure!

Page 9 Chapter 1 This chapter describes the general features of the barebone server.


Be respectful, keep it civil and stay on topic. Open the bezel to access the front panel components. Contents Safeguards Chapter 3: A new version of HDMI is coming, and there are some big changes — including support for resolutions up to 10K as well as a new cable. Remove the metal plate completely.

To easily remove the fan cage, try to slightly push it inward toward the motherboard before pulling it out of the chassis. The picture below shows the location of jumper J1 with pins and shorted. Operation is subject to the Push the power supply all the way in until its outer end aligns with the rear panel.

ASUS AP130-E1 Benutzerhandbuch

To install a floppy disk drive: After making all the connections, replace the system case cover. Push down the chassis lock to secure the side cover. Remove the HDD fan cage. Remove the plastic card lock that secures the expansion card.

Place a SATA hard disk into the drive tray, and secure it with four screws. When the card is in place, secure it with the ssus card lock that you removed earlier. Page 4 Contents 2.


Series Sign in to comment Be respectful, keep it civil and stay on topic. Expansion Cards Release the card lock by pressing the center tabs and pushing outward. Detailed descriptions of the PCI Jumpers 1.

Installing A Dimm 2. Page 17 Chapter 2 This chapter lists the hardware setup procedures that you have to perform when installing or removing system components. Page 60 For convenient transport, install the roller wheels the came with the system package.

Asus AP130-E1 User Manual

Use a flat screwdriver to flip out the top layer of a footpad. Seite von 92 Los.

Failure to do so may cause damage to the motherboard and other system components! Refer to the table for the jumper J1 setting settings and the appropriate ID for shorted, shorted. Laptops by Justin Jaffe Dec 17,